[Next] [Previous] [Up] [Top] [Contents] [Back]

5.5 Module ID

5.5.1 ID7 Control Register

The ID7 Control Register is used to control bit 7 of the module ID Register at $600001. Since the contents of the Module ID Register is read during an interrupt acknowledge cycle for VMEbus Interrupts, the ID7 Control Registers allows manipulation of the Status/ID byte. At power up the ID7 bit is cleared to '0'. This will set the Status/ID byte to: Module ID + $60.

Figure 5-3 ID7 Control Register

[Next] [Previous] [Up] [Top] [Contents] [Back]