[Next] [Previous] [Up] [Top] [Contents] [Back]

Chapter 3 Programming Considerations

3.7 Reset

The reset signal from the VMEbus will reset the BIM control registers to all zero's (the interrupt enable bits are cleared) and the vector registers to the value $0F. This is the uninitialized vector for the MC68000. No other registers on the board are affected by a reset.

CC92 - Isolated Digital Input Board - 3 OCT 1996
Copyright © 1996 Compcontrol, Inc.

[Next] [Previous] [Up] [Top] [Contents] [Back]