4.6 Stand Alone Configuration

The CC175 can be used in a stand alone configuration without using a VMEbus backplane. When the CC175 is used outside a VMEbus rack, the following signals must be terminated with a 3.9 kOhm pull-up resistor.

Signals to be Pulled-up.
P1 Pin Number	Signal
A12	DS1*
A13	DS0*
A14	WRITE*
A16	DTACK*
A18	AS*
A20	IACK*
C11	BERR*
C12	SYSRESET*
C13	LWORD*

CC175 - Dual Channel Intelligent CAN Interface for VMEbus - 30 SEP 1996

[Next] [Previous] [Up] [Top] [Contents] [Back]