[Next] [Previous] [Up] [Top] [Contents] [Back]

5.8 CAN Controllers

5.8.1 RESET OUT Function

Two RESET OUT signals are available at the CAN Physical Interface. One signal is available at JB9 for CAN Channel 0, the other RESET OUT signal is available at JB10 for CAN Channel 1.

The RESET OUT signal is used in a T-CANnector environment and can be used to indicate error on node.

Setting the RESET OUT bits to zero results in a low RESETOUT signal.

Figure 5-6 RESET OUT

CC175 - Dual Channel Intelligent CAN Interface for VMEbus - 30 SEP 1996
Copyright © 1996 Compcontrol, Inc.

[Next] [Previous] [Up] [Top] [Contents] [Back]