[Next] [Previous] [Up] [Top] [Contents] [Back]

3.2 Group Description

3.2.6 Reset Operation

A total reset is initiated by a write access to the Group Reset Register. Depending on the state of the quadrature signals, the counters can be cleared, or set to +1 or -1. To avoid this count error (+1 or -1) after the reset, the Ua1n and the Ua2n inputs should be held to the values indicated in table 3-1 during and just after the write access. It is recommended to check if the counters are cleared after the group reset.

Reset Operation
Mode Ua1n Ua2n
0 X X
1 to 5 H H
6 to 7 L L

CC433 - 12 Channel Incremental Encoder Interface with Isolated Inputs and Cable Fault Detection - 22 MAY 1997
Copyright © 1997 Compcontrol, Inc.

[Next] [Previous] [Up] [Top] [Contents] [Back]