[Next] [Previous] [Up] [Top] [Contents] [Back]

Chapter 3 Functional Description

3.3 Bus Interrupt Module

The Bus Interrupter Module on the CC433 generates interrupt requests to the VMEbus and handles interrupt acknowledge cycles.

For each group on the CC433, the interrupt capability is enabled/disabled by writing to the corresponding control registers of the BIM. In addition, each group has its own interrupt vector, which is used during the interrupt acknowledge cycle.

CC433 - 12 Channel Incremental Encoder Interface with Isolated Inputs and Cable Fault Detection - 22 MAY 1997
Copyright © 1997 Compcontrol, Inc.

[Next] [Previous] [Up] [Top] [Contents] [Back]