[Next] [Previous] [Up] [Top] [Contents] [Back]

4.3 Jumper Settings

4.3.3 Local Bus Time Out

Jumper JB3 is used to select the local bus time out function. When no jumper is installed (default), the bus time out circuit will generate a Bus Error response to the MPU, when a bus access (Address Strobe active) is not acknowledged within 2.4 µs.

Figure 4-3 Local Bus Time Out Select

CC175 - Dual Channel Intelligent CAN Interface for VMEbus - 30 SEP 1996
Copyright © 1996 Compcontrol, Inc.

[Next] [Previous] [Up] [Top] [Contents] [Back]